hardware_specs_and_theory_of_operation
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Last revision Both sides next revision | ||
|
hardware_specs_and_theory_of_operation [2019/12/20 14:20] turo [Data output] |
hardware_specs_and_theory_of_operation [2019/12/20 14:21] turo [Data output] |
||
|---|---|---|---|
| Line 69: | Line 69: | ||
| ==== Data output ==== | ==== Data output ==== | ||
| - | There are 4 data lines which can either drive two 1-Wire signals or two serial data (Clock+Data) at 5V TTL. | + | There are 4 data lines which can either drive two 1-Wire or two serial data (Clock+Data) signals at 5V TTL. |
| If the device is configured for Analog RGB mode some of the data lines are hard-rewired to Power MOSFETs instead of to the internal 5V TTL voltage and can drive up to 6A of power. | If the device is configured for Analog RGB mode some of the data lines are hard-rewired to Power MOSFETs instead of to the internal 5V TTL voltage and can drive up to 6A of power. | ||
hardware_specs_and_theory_of_operation.txt ยท Last modified: 2019/12/20 14:22 by turo
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
