This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Last revision Both sides next revision | ||
getting_started [2019/12/20 13:32] turo [Powering your LED strips] |
getting_started [2019/12/30 05:45] turo [Setting the right output voltage] |
||
---|---|---|---|
Line 25: | Line 25: | ||
Before wiring up your LED strip make sure you select the right output voltage on the Lightkraken board. Look at the above table for the right voltage. | Before wiring up your LED strip make sure you select the right output voltage on the Lightkraken board. Look at the above table for the right voltage. | ||
- | * **5V** -> Set the switch to the left-most position. The switch should point towards the RJ45 connector. | + | * **5V** -> Set the switch to the left-most position. The switch should point towards the Ethernet/Network/RJ45 connector. |
{{:switch_left.jpg?150|}} | {{:switch_left.jpg?150|}} | ||
* **12V** -> Set the switch to the middle position. | * **12V** -> Set the switch to the middle position. |